Inverter Charger 48V Victron Multiplus 48/2000 25A-32A

If connected with a GX device (e.g. the Victron Cerbo GX MK2 Monitoring - BPP900451100) you can monitor and control the inverter charger and your system(s) locally (LAN) or remotely via the Internet from anywhere in the world with the free VRM app and the free portal VRM. Access can be carried out from a phone, tablet or PC with different operating systems. There is no limit to the level of control, from setting the inverter charger to automatic start of a standby generator. And much more...

Proven reliability

The full-bridge plus toroidal transformer topology has proven its reliability over many years. The inverter is short-circuit proof and protected against overheating, whether due to overload or high ambient temperature.

PowerControl - Limited power from generator, shore power or mains power

In the Multi Control Panel a maximum current from the generator or pontoon can be set. The Victron Multiplus 48V inverter charger 48/2000 25-32 - PMP482200000 will take over other AC loads and use the surplus current for charging, thus avoiding overloading the generator or the shore power.

PowerAssist - Increasing the electrical capacity of the shore power outlet or generator

When a power peak is required for a short period of time, as is often the case, the inverter charger will immediately compensate the possible lack of power from the grid current or generator with power from the battery. When the load is reduced, the excess power is used to recharge the battery.

Variable four-stage charger and charging of dual battery banks

The main output provides a powerful charge to the battery system via advanced "variable charge" software. The software fine-tunes the automatic three-stage process to suit battery conditions and adds a fourth stage for extended periods of float. In addition, the MultiPlus can charge a second battery using a separate limited charge output designed to charge a starter battery from the main engine or generator.

Inverter starter high power 48V charger Victron Multiplus 48/2000 25-32 - PMP482200000

Necessary for starting loads with high inrush current, such as converters for LED lamps, halogen lamps or power tools.

Search mode

When the search mode is activated, the consumption of the inverter in no-load operation decreases by approximately 70%. In this mode the 48V Victron Multiplus 48/2000 25-32 - PMP482200000, when operating in inverter mode, switches off if there is little or no load, and switches back on every two seconds for a short period of time. If the output current exceeds a preset level, the inverter will continue to operate. Otherwise, the inverter will shut down again.

Programmable relay

The programmable relay is by default configured as alarm relay, i.e. the relay will be de-energised in case of alarm or pre-alarm (inverter is too hot, input ripple is almost too high and battery voltage is too low).

Datasheet Inverter Charger 48V Victron Multiplus 48/2000 25-32 - PMP482200000