ZYC SIMPO 5000i Battery · 5.12 kWh, 51.2 V LiFePO4 with circuit breaker

The ZYC SIMPO 5000i is the entry-level model in the SIMPO range: same 19″ rack format, same capacity of 5.12 kWh at 51.2 V and the same built-in circuit breaker, with slightly lower temperature and current ratings than the SIMPO 5000.

Key points

• Integrated 1P circuit breaker in the module itself: it acts as an ON/OFF switch and protects the system, without the need for an external battery-powered circuit breaker.
• LFP prismatic cells with a proven track record in ESS installations.
• Automatic configuration No app required: up and running in minutes.
• Hot swap without disrupting the system.
• Up to 80 modules in parallel without any external management devices.
• CAN / RS485 communication or operation without communication.
• 10-year warranty at 60 % efficiency.

Differences compared with the SIMPO 5000

It’s worth bearing this in mind before you buy, as the name can be misleading: The 5000i is not a higher-spec version, but rather the input option.

If the battery is going to be kept in a cold environment or if you’ll be demanding a high charging current, choose the SIMPO 5000. If it’s going to be kept in a temperature-controlled indoor cupboard with moderate power consumption, the 5000i is perfectly adequate and offers better value for money.

Compatibility with inverters

Victron Energy, Studer, SMA Sunny Island, Deye SUN series, Goodwe, Solis, Selectronic, Steca and Noark. Check the guide for the minimum number of modules required for your system How many batteries do I need, depending on my inverter? and, if you use Victron, in the setup guide.

Technical specifications

To complete the installation

• Pre-wired cabinet with 6 units o 10 units
• Floor stand, cable kit y quick-connect fittings
• WiFi module for remote monitoring
• Installation and Commissioning Guide
• The entire ZYC Energy range