Victron Smart Battery Protect 12/24V 100A

Discover the Smart Battery Protect 12/24V 100A Features

Protects the battery from excessive discharging and can be used as a system on/off switch

Smart BatteryProtect disconnects non-essential loads from the battery before it is fully discharged (which would damage the battery) or before it runs out of sufficient charge to start the engine. The on/off input can be used as a system on/off switch.

12/24V self-regulating

The Smart BatteryProtect detects the system voltage automatically and only once.

Bluetooth: easy programming

When programming the Smart BatteryProtect via Bluetooth, the desired activation/deactivation levels can be defined. Alternatively, the programming pin can be used to define one of the nine activation/deactivation levels (see manual). If necessary, Bluetooth can be disabled.

A special configuration for Li-Ion batteries

In this mode, BatteryProtect can be controlled via the VE.Bus BMS.

Note: BatteryProtect can also be used as a charging switch between a battery charger and a Li-ion battery. See the connection diagram in the manual.

Ultra-low power consumption

This is important in the case of Li-Ion batteriesespecially after a low voltage disconnection. Please refer to our Li-Ion battery data sheet and the VE.Bus BMS manual for more information.

Overvoltage protection

To prevent damage to sensitive loads due to overvoltage, the load is switched off when the DC voltage exceeds 16.3V or 32.6V respectively.

Fireproofing

Without relays but with MOSFET switches, therefore no sparks.

Delayed alarm output

The alarm output is activated if the battery voltage drops below the preset cut-off level for more than 12 seconds. Therefore, starting the engine will not activate the alarm. The alarm output is a short-circuit proof open collector output to the negative (minus) rail, with a maximum current of 50 mA. Normally, the alarm output is used to activate an acoustic signal, an LED or a relay.

Disconnection and delayed reconnection of the load

The load shall be disconnected 90 seconds after the battery voltage drops below the preset level. If the battery voltage rises back towards the switch-on threshold within this period of time (after e.g. the engine has been started), the load shall not be disconnected. The load shall reconnect 30 seconds after the battery voltage has risen above the preset reconnection level.

Datasheet Victron Smart Battery Protect 12/24V 100A - BPR110022000

View Victron Smart Battery Protect 12/24V 100A - BPR110022000 - Victron Smart Battery Protect 12/24V 100A - BPR110022000