Victron Smart Battery Protect 12/24V 220A

The Victron Smart Battery Protect 12/24V 220A - BPR122022000 disconnects non-essential loads from the battery before it is fully discharged (which would damage the battery) or before it runs out of charge enough to start the engine. The on/off input can be used as a system on/off switch.

12/24V self-regulating

The Smart BatteryProtect detects the system voltage automatically and only once.

Bluetooth: easy programming

When programming the Victron Smart Battery Protect 12/24V 220A - BPR122022000 via Bluetooth, the desired activation/deactivation levels can be defined. Alternatively, the programming pin can be used to define one of the nine activation/deactivation levels (see manual).

A special configuration for Li-Ion batteries

In this mode, BatteryProtect can be controlled via the VE.Bus BMS.
Note: BatteryProtect can also be used as a charging switch between a battery charger and a Li-ion battery. See the connection diagram in the manual.

Ultra-low power consumption

This is important in the case of Li-Ion batteries, especially after a low voltage disconnection.

Overvoltage protection

To prevent damage to sensitive loads due to overvoltage, the load is switched off when the DC voltage exceeds 16.3V or 32.6V respectively.

Fireproofing

Without relays but with MOSFET switches, therefore no sparks.

Delayed alarm output

The alarm output is activated if the battery voltage drops below the preset cut-off level for more than 12 seconds. Therefore, starting the engine will not activate the alarm. The alarm output is a short-circuit proof open collector output on the negative (minus) rail, maximum current 50 mA. The alarm output is normally used to activate a buzzer, LED or relay.

Delayed load disconnection and delayed reconnection

Datasheet Victron Smart Battery Protect 12/24V 220A - BPR122022000

View Victron Smart Battery Protect 12/24V 220A - BPR122022000 datasheet