Victron Phoenix 12V 3000VA Smart Inverter

Victron Phoenix 12V 3000VA Smart Inverter

The Victron Phoenix 12V 1600VA Smart Inverter is an efficient and reliable inverter. Built on the proven Phoenix inverter platform, it now comes with a new slimmer design in an all-metal housing. Models are available in 1600VA, 2000VA, 3000VA and 5000VA for 12, 24 or 48V systems.

It is powerful enough to power the most common devices in your car, boat, caravan or even in your home. Thanks to its toroidal transformer it has a high capacity to cope with power peaks, a stable voltage and frequency and a high quality sine wave.

Installation is now much simpler than before, with terminals that are much more accessible to the installer, allowing for a more professional finish.

Its integrated Bluetooth makes configuring your high-power inverter easier than ever. Configure alarms, alarm relay, voltage outages, output voltage, frequency, eco mode and more, all from the app. VictronConnect.

Built-in Bluetooth: fully configurable with a tablet or smartphone

- Low battery voltage alarm
- Low battery voltage shutdown and restart levels.
- Dynamic disconnection: load-dependent disconnection level
- Output voltage: 210 - 245V
- Frequency: 50 Hz or 60 Hz
- ECO mode on/off and ECO mode level sensor
- Alarm relay

Follow-up:

- Input and output voltage, load and alarms

VE.Direct communication port

The VE.Direct port can be connected to a computer (a VE.Direct interface cable is required) to configure and monitor the same parameters.

Proven reliability

The full-bridge plus toroidal transformer topology has proven its reliability over many years.
The inverters are short-circuit proof and protected against overheating, either due to overload or high ambient temperature.

High starting power

Necessary for starting loads such as converters for LED lamps, halogen lamps or power tools.

ECO Mode

In ECO mode, the inverter will go into standby when the load drops below a preset value. Once in standby, the inverter will activate briefly every 2.5 seconds (adjustable).
If the load exceeds the preset level, the inverter will remain on.

Remote on/off switch

A remote On/Off switch or relay can be connected to a two-phase connector.
Alternatively, the H (left) terminal of the two-phase connector can be switched to battery positive, or the L (right) terminal of the two-phase connector can be switched to battery negative (or to a vehicle chassis, for example).

Datasheet Victron Phoenix Inverter 12V 3000VA Smart - PIN122300000

View Victron Phoenix Inverter 12V / 3000VA Smart - PIN122300000 datasheet