Victron Smart Battery Protection Smart BatteryProtect 12/24V 65A - BPR065022000

Protects the battery from excessive discharges and can be used as a system on/off switch

The Smart BatteryProtect 12/24V 65A disconnects non-essential loads from the battery before it is fully discharged (which would damage the battery) or before it runs out of sufficient charge to start the engine. The on/off input can be used as a system on/off switch.

12/24V self-regulating

The Smart BatteryProtect 12/24V 65A detects the system voltage automatically and only once.

Bluetooth: easy programming

When programming the Smart BatteryProtect 12/24V 65A via Bluetooth, the desired activation/deactivation levels can be defined. Alternatively, the programming pin can be used to define one of the nine activation/deactivation levels (see manual).
If necessary, Bluetooth can be disabled.

A special configuration for Li-Ion batteries

In this mode, BatteryProtect can be controlled by the VE.Bus BMS.
Note: BatteryProtect can also be used as a charging switch between a battery charger and a Li-ion battery. See the connection diagram in the manual.

Ultra low current consumption

This is important in the case of Li-Ion batteries, especially after a low voltage disconnection.
See our Li-Ion battery datasheet and VE.Bus BMS manual for more information.

Overvoltage protection

To avoid damage to sensitive loads due to overvoltage, the load is disconnected when the DC voltage exceeds 16.3V or 32.6V respectively.

Fireproof

No relays but with MOSFET switches, therefore no sparks.

Delayed alarm output

The alarm output is activated if the battery voltage drops below the preset cut-off level for more than 12 seconds. Therefore, starting the engine will not activate the alarm. The alarm output is a short-circuit proof open collector output to the negative (minus) rail, with a maximum current of 50 mA. Normally, the alarm output is used to activate an acoustic signal, an LED or a relay.

Load disconnection and delayed load reconnection

The load will be disconnected 90 seconds after the battery voltage drops below the preset level. If the battery voltage rises back towards the switch-on threshold within this time period (after, for example, the engine has been started), the load will not be disconnected.
The load will be reconnected 30 seconds after the battery voltage has risen above the level of
default reconnection.

Datasheet Victron Smart BatteryProtect 12/24V 65A Smart Battery Protection - BPR065022000

See Victron Smart BatteryProtect 12/24V 65A Smart Battery Protection - BPR065022000