Inverter Victron Multiplus 12V 800VA 35-16A - PMP121800000

If connected to a GX device (e.g., a Cerbo GX) you can monitor and control the Victron Multiplus Inverter and your system(s) locally (LAN) or remotely via the Internet from anywhere in the world with the free VRM app and the free portal VRM.

Access can be carried out from a phone, tablet or PC with different operating systems. The level of control is limitless, from setting the Victron Multiplus Inverter 12V 800VA 35-16A to the automatic start of a standby generator. And much more...

Proven reliability

The full-bridge plus toroidal transformer topology has proven its reliability over many years. The inverter is short-circuit proof and protected against overheating, either due to overload or high ambient temperature.

PowerControl - Limited power from generator, shore power or mains power

In the Multi Control Panel a maximum current from the generator or the dock can be set. The Victron Multiplus Inverter 12V 800VA 35-16A will take over other AC loads and use the excess current for charging, thus avoiding overloading the generator or the shore power.

PowerAssist - Increased electrical capacity of shore power or generator

When a power peak is required for a short period of time, as often happens, the Victron Multiplus Inverter 12V 800VA 35-16A will immediately compensate the possible lack of power from the grid current or generator with power from the battery. When the load is reduced, the excess power is used to recharge the battery.

Four-stage variable charger and charging of dual battery banks

The main output provides a powerful charge to the battery system by means of advanced "variable charge" software. The software fine-tunes the automatic three-stage process to match battery conditions and adds a fourth stage for extended float periods.

In addition, the MultiPlus can charge a second battery using a separate limited charge output designed to charge a starter battery from the main engine or generator.

High starting power

Necessary for starting loads with high inrush current, such as converters for LED lamps, halogen lamps or power tools.

Search mode

When the search mode is activated, the consumption of the inverter in no-load operation decreases by approximately 70%. In this mode the Victron Multiplus Inverter 12V 800VA 35-16A, when operating in inverter mode, switches off if there is no load or very little load, and switches back on every two seconds for a short period of time.

If the output current exceeds a preset level, the inverter will continue to operate. Otherwise, the inverter will shut down again.

Programmable relay

The programmable relay is by default configured as an alarm relay, i.e. the relay will be de-energized in case of alarm or pre-alarm (inverter is too hot, input ripple is almost too high and battery voltage is too low).