Charger Victron Phoenix Smart IP43 12/30 (1+1) 230V - PSC123051085

Integrated Bluetooth Smart

The wireless solution for configuring, monitoring, controlling and updating Phoenix Smart IP43 chargers.

Phoenix Smart (1+1): two outputs to charge 2 battery banks

The second output, limited to approximately 3 A and with a slightly lower output voltage, is intended for recharging a starter battery.

Phoenix Smart (3): three full current outputs to charge 3 battery banks

Each output can supply the full rated output current. But the total of the 3 outputs combined can never exceed the current rating of the charger.

Automatic voltage compensation

The charger compensates for the voltage drop in the DC wiring by slightly increasing the output voltage when the DC current increases.

6-stage adaptive loading algorithm: volume, absorption, reconditioning, floating, storage, upgrade

The Phoenix Smart Charger features our popular 'adaptive' battery management system that can be preset to suit different types of batteries. The 'adaptive' feature will automatically optimize the charging process in relation to how the battery is used.

Less maintenance and aging when the battery is not in use: storage mode

The storage mode is activated as long as the battery has not been discharged for 24 hours. In storage mode, the float voltage is reduced to 2.2 V/cell (13.2 V for a 12 V battery) to minimize gassing and corrosion of the positive plates. Once a week, the voltage is raised back to the absorption level to 'equalize' the battery. This feature prevents electrolyte stratification and sulfation, a major factor causing early battery failure.

Temperature and voltage sensing of the optional external battery via Bluetooth

A smart battery sensor, SmartShunt or BMV-712 smart battery monitor can be used to communicate battery voltage and temperature to one or more Phoenix Smart IP43 chargers via VE.Smart Networks.

Remote on/off

The remote on/off consists of two terminals: Remote H and Remote L. A remote on/off switch or relay contact can be connected between H and L. Alternatively, the H terminal can be placed high, or the L terminal can be pulled low. See manual for details.

VE.Direct interface

For a wired data connection to a GX device such as Cerbo GXPC or other devices. It also allows instant readout functionality via VictronConnect remotely from VRM. See VictronConnect application

Programmable relay

Can be programmed using the VE.Direct interface or a Bluetooth-enabled device to trigger an alarm or other events

Technical Data Charger Victron Phoenix Smart IP43 12/30 (1+1) 230V - PSC123051085

See Victron Phoenix Smart Charger IP43 12/30 (1+1) - PSC123051085 datasheet