Diode bridge Victron Argodiode 100-3AC - 3 batteries 100A - ARG100301000R

Diode bridge Victron Argodiode 100-3AC - 3 batteries 100A - ARG100301000R

Diode bridges allow different batteries to be charged simultaneously from a single alternator, without connecting the batteries together. Even when discharged, the batteries remain isolated, so that the use of the service battery, for example, cannot discharge the starter battery.

ARGO diode bridges have a reduced voltage drop due to the use of Schottky diodes: at low current, the loss will be approximately 0.3 V, and at full output, 0.45 V. All models are equipped with a compensation diode which allows the alternator output voltage to be slightly increased to compensate for the voltage loss of the diode bridge. For best results, see our ARGO FET diode bridges without voltage drop.

See our free book "Energy Without Limits". or ask a specialist for advice to install a diode bridge. Voltage losses caused by the use of diode bridges can decrease battery performance due to incomplete charging.

Alternator power supply input

Some alternators require a DC voltage on the B+ output to start charging. Obviously, DC will be present when the alternator is connected directly to the battery. However, if a diode bridge or FET separator is inserted, any voltage/current return from the batteries to the B+ output will be prevented, and the alternator will not be activated.
The new "AC" diode jumpers have a special current limiting input that will feed the B+ output when the motor start/stop switch is closed.

Datasheet Victron Argodiode 100-3AC diode bridge - 3 batteries 100A - ARG100301000R

See the technical data sheet of the diode bridge Victron Argodiode 100-3AC - 3 batteries 100A - ARG100301000R