Charger Victron Phoenix Smart IP43 12/30 (1+1) 120-240V - PSC123051095

Features Charger Victron Phoenix Smart IP43 12/30 (1+1) 120-240V

Integrated Bluetooth Smart

The Victron Phoenix Smart IP43 12/30 (1+1) 120-240V charger has an integrated wireless solution for configuring, monitoring, controlling, updating and synchronizing the Phoenix Smart IP43 chargers.

Phoenix Smart (1+1): two outlets to charge 2 battery banks

The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to fully charge a starter battery.

Phoenix Smart (3): three full current outputs to charge 3 battery banks

Each of the outputs can supply the full rated output current. But the three outputs combined can never exceed the rated current of the charger.

Automatic voltage compensation

The Victron Phoenix Smart IP43 12/30 (1+1) 120-240V charger compensates for the voltage drop of DC cables by gradually increasing the output voltage when DC current increases. Please refer to the manual for more information.

6-stage adaptive loading algorithm: initial loading - absorption - reconditioning - floating - storage - refreshing

The Phoenix Smart Charger features our well-known "adaptive" battery management system that can be configured for different battery types. Its "adaptive" function will automatically optimize the charging process based on the battery usage.

The right amount of load: adaptive absorption time

When the discharge is low (e.g. a yacht connected to the pontoon) the absorption charging phase is shortened to avoid overcharging the battery. After a deep discharge, the absorption charge time is automatically increased to ensure a complete recharge of the battery.

Preventing damage due to overgassing: BatterySafe mode

If, in order to charge a battery quickly, a combination of high charge current with high absorption voltage has been chosen, the charger will prevent damage from over-gassing by automatically limiting the rate of voltage increase once the gassing voltage has been reached.

Reduced aging and need for maintenance when the battery is not in use: storage mode.

The storage mode is activated when the battery has not been discharged for 24 hours. In storage mode, the float voltage is reduced to 2.2 V/cell (13.2 V for 12 V batteries) to minimize gassing and corrosion of the positive plates. Once a week, the voltage is brought back up to the absorption level to "equalize" the
battery. This function prevents electrolyte stratification and sulfation, the main causes of battery failure.

Also charges lithium-ion batteries (LiFePO₄).

Simple on/off control can be implemented by connecting a relay or optocoupler with open collector output from a Li-Ion BMS to the remote on/off port. Alternatively, full voltage and current control is also possible via Bluetooth.

Fully programmable loading algorithm in the

Charger Victron Phoenix Smart IP43 12/30 (1+1) 120-240V

The charging algorithm can be programmed via Bluetooth or the VE.Direct interface. Three preprogrammed charging algorithms can be selected with the mode button (see specifications).

Optional external battery voltage and temperature sensor via Bluetooth

A Smart Battery Sense sensor or BMV-712 Smart battery monitor can be used to communicate battery voltage and temperature to one or more Phoenix Smart IP43 chargers.

Remote On/Off

• The remote on/off consists of two terminals: H remote and L remote.
• A remote on/off switch or relay contact between H and L can be connected.
• Alternatively, the H terminal can be set at a higher level or the L terminal can be set at a lower level.
  Refer to the manual for details.

VE.Direct interface

For a wired data connection to a GX device, such as the Cerbo GXto a PC or other devices. It also enables the Instant Readout function, through VictronConnect remotely from the VRM.

Programmable relay

It can be programmed with the VE.Direct interface or with a Bluetooth-enabled device to trigger an alarm or other events.

Synchronized loading

When pairing two or more Phoenix Smart IP43 chargers in a VE.

Datasheet Victron Phoenix Smart Charger IP43 12/30 (1+1) 120-240V - PSC123051095

View Victron Phoenix Smart Charger IP43 12/30 (1+1) 120-240V - PSC123051095 datasheet