The Victron Phoenix Smart IP43 12\/50 (3) 120-240V charger has an integrated wireless solution for configuring, monitoring, controlling, updating and synchronising the Phoenix Smart IP43 chargers.<\/p>\n
The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to fully charge a starter battery.<\/p>\n
Each of the outputs can supply the full rated output current. But the three outputs combined can never exceed the rated current of the charger.<\/p>\n
The Victron Phoenix Smart IP43 12\/30 (1+1) 120-240V charger compensates for the voltage drop of DC cables by gradually increasing the output voltage as the DC current increases. Please refer to the manual for more information.<\/p>\n
The Phoenix Smart Charger features our well known \"adaptive\" battery management system that can be configured for different battery types. Its \"adaptive\" function will automatically optimise the charging process according to the usage of the battery.<\/p>\n
When the discharge is low (e.g. a yacht connected to the pontoon) the absorption charging phase is shortened to avoid overcharging the battery. After a deep discharge, the absorption charge time is automatically increased to ensure a full recharge of the battery.<\/p>\n
If, in order to charge a battery quickly, a combination of high charging current and high absorption voltage has been chosen, the charger will prevent damage from over-gassing by automatically limiting the rate of voltage increase once the gassing voltage has been reached.<\/p>\n
The storage mode is activated when the battery has not been discharged for 24 hours. In storage mode, the float voltage is reduced to 2.2 V\/cell (13.2 V for 12 V batteries) to minimise gassing and corrosion of the positive plates. Once a week, the voltage is brought back up to the absorption level to \"equalise\" the
\nbattery. This function prevents electrolyte stratification and sulphation, the main causes of battery failure.<\/p>\n
Simple on\/off control can be implemented by connecting a relay or optocoupler with open collector output from a Li-Ion BMS to the remote on\/off port. Alternatively, it is also possible to have full voltage and current control via Bluetooth.<\/p>\n
The charging algorithm can be programmed via Bluetooth or the VE.Direct interface. Three pre-programmed charging algorithms can be selected with the mode button (see specifications).<\/p>\n
A Smart Battery Sense sensor or BMV-712 Smart battery monitor can be used to communicate battery voltage and temperature to one or more Phoenix Smart IP43 chargers.<\/p>\n
For a wired data connection to a GX device, such as the Victron Cerbo GX MK2 Monitoring - BPP900451100<\/a>to a PC or other devices. It also enables the Instant Readout feature, through VictronConnect<\/a> remotely from the VRM.<\/p>\n It can be programmed with the VE.Direct interface or a Bluetooth-enabled device to trigger an alarm or other events.<\/p>\n When pairing two or more Phoenix Smart IP43 chargers on a VE.S network<\/p>\nProgrammable relay<\/h2>\n
Synchronised charging<\/h2>\n
Datasheet Victron Phoenix Smart Charger IP43 12\/50 (3) 120-240V - PSC125053095<\/h2>\n