Inverter 12V Victron Multiplus 12V 1200VA 50-16A 120V VE.Bus - PMP122120100

If connected with a GX device, such as the Victron Cerbo GX MK2 Monitoring - BPP900451100The Victron Multiplus Inverter and your system(s) can be monitored and controlled locally (LAN) or remotely over the Internet from anywhere in the world with the free VRM app and the free VRM portal.

Access can be carried out from a phone, tablet or PC with different operating systems. The level of control is limitless, from setting the Victron Multiplus Inverter 12V 1200VA 50-16A to the automatic start of a standby generator. And much more...

Proven reliability of the 12V Inverter Victron Multiplus 12V 1200VA 50-16A 120V VE.Bus - PMP122120100

The full-bridge plus toroidal transformer topology has proven its reliability over many years. The inverter is short-circuit proof and protected against overheating, whether due to overload or high ambient temperature.

PowerControl - Limited power from generator, shore power or mains power

In the Multi Control Panel a maximum current from the generator or the pontoon can be set. The 12V Inverter Victron Multiplus 12V 1200VA 50-16A 120V VE.Bus - PMP122120100 will take over other AC loads and use the surplus current for charging, thus avoiding overloading the generator or the shore power.

PowerAssist - Increasing the electrical capacity of the shore power outlet or generator

When a power peak is required for a short period of time, as is often the case, the 12V Victron Multiplus 12V 1200VA 50-16A 120V VE.Bus - PMP122120100 inverter will immediately compensate the possible lack of power from the mains or generator current with power from the battery. When the load is reduced, the excess power is used to recharge the battery.

Variable four-stage charger and charging of dual battery banks

The main output provides a powerful charge to the battery system via advanced "variable charge" software. The software fine-tunes the automatic three-stage process to match battery conditions and adds a fourth stage for extended periods of float.

In addition, the MultiPlus can charge a second battery using a separate limited charge output designed to charge a starter battery from the main engine or generator.

High starting power 12V Inverter Victron Multiplus 12V 1200VA 50-16A 120V VE.Bus - PMP122120100

Necessary for starting loads with high inrush current, such as converters for LED lamps, halogen lamps or power tools.

Search mode

When the search mode is activated, the consumption of the inverter in no-load operation decreases by approximately 70%. In this mode the Victron Multiplus Inverter 12V 1200VA 50-16A, when operating in inverter mode, switches off if there is no load or very little load, and switches back on every two seconds for a short period of time.

If the output current exceeds a preset level, the inverter shall continue to operate. Otherwise, the inverter will shut down again.

Programmable relay

The programmable relay is by default configured as alarm relay, i.e. the relay will be de-energised in case of alarm or pre-alarm (inverter is too hot, input ripple is almost too high and battery voltage is too low).